Overview

If you're looking for a bed mattress that can keep up with your electric profiling bed, look no further than Softform Maxi Glide.

Our patented design supports patients in position while profiling, reducing the risk of shear and friction against tissue.

Plus, our pressure-reducing design provides unmatched comfort for patients. Make sure your patients get the best night's sleep possible with Softform Maxi Glide!

This product is not returnable/refundable

Features	Benefits
Patented Glide system allows mattress to fully conform to the bed frame	Optimizes the properties of a profiling bed
Top surface remains under patient throughout profiling of an electric bed	Significantly reduces shear and friction forces, most particularly on the heel areas which are especially vulnerable to pressure ulcer development
Cover fabric conforms to deep contoured foam castellations on upper surface of the insert pad when mattress is profiled	Minimizes rucking of cover fabric on top surface, reducing potential for tissue damage
Does not require turning or rotating	Significantly reduces manual handling issues and helps to facilitate staff management resources
Two-way stretch PU waterproof cover	Provides excellent recovery and durability
High frequency welded seams	Reduces risk of fluid ingress and positively contributes to infection control
Full length flap conceals the zip	Reduces possible fluid ingress through the zip
Toughened PU coated base	Prolongs longevity of the mattress and reduces the risk of strikethrough, hydrolysis and delamination
Deep contoured insert pad for enhanced pressure area care	Maximise body contact area ond optimizes pressure reduction
Single piece foam 'U'core	Facilitates patient transfer by providing effective side-wall support
Does not impede CPR procedures	Clinically assessed to ensure this does not occur
Double-coated PU sides	Reduces potential for physical damage
Optional Evacuation Straps	Provides extra safety for the patient and carer in case of an emergency
Water penetration resistance	35 kPa minimum (BS 3424: part 26). 35 kPa minimum after 20,000 cycles Martindale Abrasion Testy EN ISO 5470-2